Termo-Kont MK

Advanced Time and Temperature Functionality

If configured, Endicate's advanced time and temperature functionality allows you to determine when a temperature breach has occurred within your supply chain. This feature is available to track all 4 alarms and is available as long as your device is configured with stop mode enabled.


  
0 hours ago

  
0 hours ago

  
0 hours ago

  
0 hours ago

How To Use

  1. Upon receipt, the device will need to be put in STOP state by holding the Start button for 2 seconds. STOP mode can be confirmed when the display shuts off.

  2. Hold the Start button again for 2 seconds to allow the device to enter the tracking state to display the following information:
  1. If none of the alarms were triggered, the device will blink "OK" and each alarm 2 times
    then proceed to STOP state.
  2. If any of the alarms were triggered, 2 things would be shown:
    - The alarms that didn't trigger would blink two times with an OK status.
    - Alarms that were triggered would blink twice with an "X", followed by a sequence of up to 6 digits. These 6 digits are important to note to determine the time of excursion. By entering the digits for each alarm below, you will know when each alarm was triggered within a 1 hour window.
Subscription
© 2011-2023. Termo-Kont MK